[antlr-interest] Setting input in the interpreter
Jim Idle
jimi at temporal-wave.com
Fri Aug 20 09:11:59 PDT 2010
Did you notice the tab that allows you to change the test rig template?
Jim
> -----Original Message-----
> From: antlr-interest-bounces at antlr.org [mailto:antlr-interest-
> bounces at antlr.org] On Behalf Of Thomas Nilsson
> Sent: Thursday, August 19, 2010 11:17 PM
> To: antlr-interest at antlr.org
> Subject: [antlr-interest] Setting input in the interpreter
>
> Is there a way to set the input stream in the interpreter, either
ANTLRWorks
> or ANTLR IDE?
>
> My grammar is case insensitive, and although there is an example on the
> Wiki on how to do this for real, I was looking for a way to run my
numerous
> test cases in the interpreter before implementing anything else.
>
> Thomas Nilsson, CTO, Agile Mentor
> Responsive Development Technologies AB
> Web: http://www.responsive.se
> Email: thomas.nilsson at responsive.se
> Phone: +46 70 561 75 41
> Blog: http://www.responsive.se/thomas
>
>
> List: http://www.antlr.org/mailman/listinfo/antlr-interest
> Unsubscribe: http://www.antlr.org/mailman/options/antlr-interest/your-
> email-address
More information about the antlr-interest
mailing list